SLC 5/04 DH+ Channel 1 & DL3500 communication?

lkkplayer

Member
L
Join Date
Dec 2020
Location
Kaosiung
Posts
11
After I tried wiring, I used computer program communication to read the PLC N value, but received a NAK signal. And the DL3500 CHA light keeps flashing. I would like to ask if there is any problem with my wiring and settings? It seems that I am not connected to the DH+. Wiring and settings are as attached.:confused:šŸ¤žšŸ»

wiring diagram.jpg DL3500 .jpg
 

Similar Topics

L
SLC 5/04 DH+ Channel 1 ( 8 pins round connector ) to DL3500??
Do someone have wiring diagram of SLC 5/04 DH+ Channel 1 ( 8 pins round connector ) to CHA NETWORK of DL3500 ?HOW to set parameter of DL3500? I'm...
2
Replies
19
Views
1,842
geniusintraining
geniusintraining
M
SLC 500 4 Channel Analog Input card set up
I'm feeling pretty stupid tonight because I can't remember process to install and set up my 1746-NI4 analog card in my SLC 500 PLC. It has been...
Replies
2
Views
3,889
Mickey
Mickey
A
channel configuration SLC 5/04
Hello guys, I will continue with beginners questions, when I was explore our factory system in slc 500 software (SLC 5/04) into folder ā€˜channel...
Replies
2
Views
5,152
daba
D
Adam303
slc 5/04 channel 0 rs-232 problem
Hey guys. Reacently i have tryed to upload a program from one of our equipmet that has a slc 5/04 and a panelview 600 connected to chanell 0 rs...
2
Replies
23
Views
6,186
Adam303
Adam303
R
SLC 505 will not allow channel configuration in offline mode!
This is a new one on me. I cannot do anything in the channel configuration tab without the error box at the top popping up. I can't change tabs or...
Replies
6
Views
5,864
Shakeelcec
S
Back
Top Bottom