PIDE CVFaulted (Status1.2) Causes

jkerekes

Member
jkerekes
Join Date
Aug 2007
Location
NJ
Posts
2,363
Studio 5000 version 34. Have error on PIDE CVFaulted (Status1.2), Control variable (CV) health bad.

No more information online or in instruction manual. What could be some of the causes of this error. Thanks.
 
I’ll check that tomorrow. I missed that. Does the status1.2 bit prevent the PIDE from going into Auto mode?
 

Similar Topics

J
Burner Cascade PIDE
Hello all, we have an homogenizing oven with three zones, 2 burners in each zone, a soak (smaller) and a main (large). during ramp to the air...
Replies
2
Views
27
jrhpuuk123
J
Ron Beaufort
RSLOGIX 5000 - SIGNAL FLOW FOR PIDE - STATES AND MODES
Greetings ... someone sent me a request for some student handsouts that I developed ... turns out that I had this hosted on my business website...
Replies
0
Views
136
Ron Beaufort
Ron Beaufort
A
PIDE Autotuning for Level Control
Have a logix controller and I'm using the PIDE block for the autotuner. I've got the hang of doing it for direct control things like pressure...
2
Replies
21
Views
1,778
drbitboy
drbitboy
P
Factory Talk Studio Global Object - PIDE PV communication failed?
Hi everyone, I am trying to add a control loop to my HMI interface however I keep getting the following issue, any idea why this would happen?
Replies
8
Views
1,619
cardosocea
C
R
Logix PIDE Scan
We have a routine that we trigger with a JSR every 10 seconds that has PIDE instructions. This resides in a Periodic task that triggers every...
Replies
6
Views
926
drbitboy
drbitboy
Back
Top Bottom