Bradley Schulz
Member
Hi, I have a panelview 600 DF1 232 model trying to have it communicate with an SLC 5/05.
The PV is using a straight through cable plugged into Ch 0 on the SLC.
I have set up a passthru and routing table etc. I was able to see it in linx when i first plugged it in and was able to download. It was communicating with the SLC as i could operate and change values.
Now it cant be seen in linx at all. I have checked all of the comm settings and they are fine. Is there a way to reset the PV back to factory settings or something?
This is my first time and dont know if i have skipped steps. If i could get some help it would be great.
The PV is using a straight through cable plugged into Ch 0 on the SLC.
I have set up a passthru and routing table etc. I was able to see it in linx when i first plugged it in and was able to download. It was communicating with the SLC as i could operate and change values.
Now it cant be seen in linx at all. I have checked all of the comm settings and they are fine. Is there a way to reset the PV back to factory settings or something?
This is my first time and dont know if i have skipped steps. If i could get some help it would be great.