Adding a 700 drive in plc-5, replacing 1336

[remullis]

I currently have a 1336 hard wired drive that I would like to swap to a 700 using a Rio adpt. How do I go about configuring this in plc 5. We currently have some in operation but i can't seem to find exactly where in the UK config where you define groups, rack size etc. Thanks

 

[James Mcquade]

get into the plc program.
select channel configuration and select channel 1a or 1b.
you can configure the port for remote I/o, remote I/o adapter, or dh+
the drive should be 1/2 rack in size.

if this is a new cable, you will need end resistors, I could be wrong on this.
I could be wrong on the size, but I don't think so.
if I am incorrect on any thing else, someone please correct me.

james