“I am using Vijeo Citect 7.10r1 on WinXP SP2 , to talk to Siemens S7-313C-DP PLC through Ethernet via CP 343-1 Card and I used Simatic Net Software as a gateway between the Citect and Siemens PLC.
I did the steps mentioned in the Knowledge Base and in S7NT Driver Help .
The connection between Simatic net and PLC was successfully established, then I defined the boards and ports and I/O Device in Citect as described in the knowledge base and S7NT driver.”
[FONT="]
But the problem was
When I try to start the project, I get the following message: [/FONT][FONT="]"S7NT not initialized".[/FONT][FONT="] Are there any suggestions ?
[/FONT]
I did the steps mentioned in the Knowledge Base and in S7NT Driver Help .
The connection between Simatic net and PLC was successfully established, then I defined the boards and ports and I/O Device in Citect as described in the knowledge base and S7NT driver.”
[FONT="]
But the problem was
When I try to start the project, I get the following message: [/FONT][FONT="]"S7NT not initialized".[/FONT][FONT="] Are there any suggestions ?
[/FONT]