Hello,
I am trying to figure out the difference between Hand Mode, Override mode and Manual mode and what advantage one has over the other. The PIDE loop i use will always be in program Mode and all these modes do what i want which is when i switch to these modes whatever value is in the corresponding input will be written to the block output and when i switch back into Auto mode it will start regulating from whatever is the existing valve output. so which mode should i use ?
I am trying to figure out the difference between Hand Mode, Override mode and Manual mode and what advantage one has over the other. The PIDE loop i use will always be in program Mode and all these modes do what i want which is when i switch to these modes whatever value is in the corresponding input will be written to the block output and when i switch back into Auto mode it will start regulating from whatever is the existing valve output. so which mode should i use ?