Can anyone confirm that using contrologix 5580 controller is not possible to work with powerflex 527? It's been a couple of days now that i am trying to configure pf527 using 1756-L82E and yet "axis is unconnected" is showing.
Given the following details below, im still stucked-up with axis unconnected.
1. pf527 appears in i/o tree with running condition
2. Motion group folder was created with "AXIS" assigned and associated to PF527
3. IP address is configured at pf527, 192.168.1.51 subnet : 255.255.255.0
4. Controller IP add of 192.168.1.2 and same subnet mask with pf527
5. A simple motion command "MAJ" is present in routine.
When im trying to use direct motion command to drive the motor there is an error
axis not configured and it turned out to be that it is due to unconnected axis. Another thing is the fp527 is having a display of "CONNECTING"
Reading the user manual leads me to conclude that pf527 is compatible only to guardlogix
Given the following details below, im still stucked-up with axis unconnected.
1. pf527 appears in i/o tree with running condition
2. Motion group folder was created with "AXIS" assigned and associated to PF527
3. IP address is configured at pf527, 192.168.1.51 subnet : 255.255.255.0
4. Controller IP add of 192.168.1.2 and same subnet mask with pf527
5. A simple motion command "MAJ" is present in routine.
When im trying to use direct motion command to drive the motor there is an error
axis not configured and it turned out to be that it is due to unconnected axis. Another thing is the fp527 is having a display of "CONNECTING"
Reading the user manual leads me to conclude that pf527 is compatible only to guardlogix
Last edited: