ChrisPulman
Member
After successfully communicating with the Allen Bradley Ultra 3000i 2098-DSD-010X-DN over DeviceNet via a 1769-SDN I preceded to configure the parameters for the drive for I/O Messages as follows:
I set Parameter 7 = Assembly Instance 9, Parameter 8 = Assembly Instance 13, Parameter 9 = Assembly Instance 13 I then power cycled the device, thereon I was unable to communicate to the device via DeviceNet.
Upon power up the 1769-SDN has the Network LED on permanently and is displaying error 91 the 1769-SDN is set to Node 00 and the Ultra 3000i to Node 01 the terminating resistors are present at either end of the 1 meter network cable measuring 60 Ohms between Can_H and Can_L there is 24 Volts DC across V+ and V-.
Any help on how to recover the drive from this situation would be great.
I set Parameter 7 = Assembly Instance 9, Parameter 8 = Assembly Instance 13, Parameter 9 = Assembly Instance 13 I then power cycled the device, thereon I was unable to communicate to the device via DeviceNet.
Upon power up the 1769-SDN has the Network LED on permanently and is displaying error 91 the 1769-SDN is set to Node 00 and the Ultra 3000i to Node 01 the terminating resistors are present at either end of the 1 meter network cable measuring 60 Ohms between Can_H and Can_L there is 24 Volts DC across V+ and V-.
Any help on how to recover the drive from this situation would be great.