Good morning,
We've had an issue with a couple of servo valves and was wondering if anyone had seen anything similar.
After a drop in pressure on 2 servo valves they quick returned to their home position and the machine went into fault. I'm only mentioning this because I believe its the first time it's happened since it was installed 2 years ago.
Afterwards in the MSO tags for both valves it's showing MSO.ER 11, from the manual for the 1756-M02AS it says the axis is not configured. Not sure how this would come about when the machines been fine for 2 years. From what I've read it may just need then program re-downloading but I'm unable to try this until Monday so wanted to see if anyone's seen anything similar beforehand?
Cheers
We've had an issue with a couple of servo valves and was wondering if anyone had seen anything similar.
After a drop in pressure on 2 servo valves they quick returned to their home position and the machine went into fault. I'm only mentioning this because I believe its the first time it's happened since it was installed 2 years ago.
Afterwards in the MSO tags for both valves it's showing MSO.ER 11, from the manual for the 1756-M02AS it says the axis is not configured. Not sure how this would come about when the machines been fine for 2 years. From what I've read it may just need then program re-downloading but I'm unable to try this until Monday so wanted to see if anyone's seen anything similar beforehand?
Cheers