andyvanosdol
Member
Hey all, first time poster here.
I am wondering if anyone has tried using a Keyence SR-X300 barcode scanner to a Micrologix 1400.
Keyence sent sample code for RSLogix500 that I have attached in a screenshot. The issue I am having is when the rung two is executed the MSG instruction errors out. In the error screenshot you can see the error is "Error code (in upper byte of MGx:y.22) was returned by Comms module or CIP device" when I monitor this byte I get the code 1F as shown in the screenshot which Rockwell says in vendor specific.
I also attached what Keyence has given me as an explanation for what the rung is doing, but is not providing any information on errors.
Has anyone had success reading from a SR-X300 to a Micrologix 1400? Would anyone have any advice on what to try/which direction I should go to help solve the error issue?
Any help is greatly appreciated!!
I am wondering if anyone has tried using a Keyence SR-X300 barcode scanner to a Micrologix 1400.
Keyence sent sample code for RSLogix500 that I have attached in a screenshot. The issue I am having is when the rung two is executed the MSG instruction errors out. In the error screenshot you can see the error is "Error code (in upper byte of MGx:y.22) was returned by Comms module or CIP device" when I monitor this byte I get the code 1F as shown in the screenshot which Rockwell says in vendor specific.
I also attached what Keyence has given me as an explanation for what the rung is doing, but is not providing any information on errors.
Has anyone had success reading from a SR-X300 to a Micrologix 1400? Would anyone have any advice on what to try/which direction I should go to help solve the error issue?
Any help is greatly appreciated!!
